Return to rc.conf CVS log

Up to [local] / src / etc

Allow nmeaattach to start a sensor before starting ntpd. Many modern
receivers can cold start in the time it takes the boot process to get
close to starting ntpd. Even if the gps is not ready or the fix is not
valid, at least the sensor has been created; ntpd won't have to wait
a few minutes before scanning for the sensor. This makes using GPS as
the sole source of time a bit easier.

ok deraadt

#!/bin/sh -
#
#	$OpenBSD: rc.conf,v 1.124 2007/03/14 20:47:17 ckuethe Exp $

# set these to "NO" to turn them off.  otherwise, they're used as flags
routed_flags=NO		# for normal use: "-q"
ripd_flags=NO		# for normal use: ""
mrouted_flags=NO	# for normal use: "", if activated
			# be sure to enable multicast_router below.
dvmrpd_flags=NO		# for normal use: ""
ospfd_flags=NO		# for normal use: ""
bgpd_flags=NO		# for normal use: ""
rarpd_flags=NO		# for normal use: "-a"
bootparamd_flags=NO	# for normal use: ""
rbootd_flags=NO		# for normal use: ""
sshd_flags=""		# for normal use: ""
named_flags=NO		# for normal use: ""
rdate_flags=NO		# for normal use: [RFC868-host] or [-n RFC2030-host]
timed_flags=NO		# for normal use: ""
nmeaattach_flags=NO	# for normal use: "[options] cua-device"
ntpd_flags=NO		# for normal use: ""
isakmpd_flags=NO	# for normal use: ""
sasyncd_flags=NO	# for normal use: ""
mopd_flags=NO		# for normal use: "-a"
apmd_flags=NO		# for normal use: ""
dhcpd_flags=NO		# for normal use: ""
dhcrelay_flags=NO	# for normal use: "-i interface [server]"
rtadvd_flags=NO		# for normal use: list of interfaces
			# be sure to set net.inet6.ip6.forwarding=1
route6d_flags=NO	# for normal use: ""
			# be sure to set net.inet6.ip6.forwarding=1
rtsold_flags=NO		# for normal use: interface
			# be sure to set net.inet6.ip6.forwarding=0
			# be sure to set net.inet6.ip6.accept_rtadv=1
lpd_flags=NO		# for normal use: "" (or "-l" for debugging)
sensorsd_flags=NO	# for normal use: ""
hotplugd_flags=NO	# for normal use: ""
watchdogd_flags=NO	# for normal use: ""
ftpproxy_flags=NO	# for normal use: ""
hostapd_flags=NO	# for normal use: ""
ifstated_flags=NO	# for normal use: ""
hoststated_flags=NO	# for normal use: ""

# use -u to disable chroot, see httpd(8)
httpd_flags=NO		# for normal use: "" (or "-DSSL" after reading ssl(8))

# For normal use: "-L sm-mta -bd -q30m", and note there is a cron job
sendmail_flags="-L sm-mta -C/etc/mail/localhost.cf -bd -q30m"
spamd_flags=NO		# for normal use: "" and see spamd-setup(8)
spamd_black=NO		# set to YES to run spamd without greylisting
spamlogd_flags=""	# use eg. "-i interface" and see spamlogd(8)

# Set to NO if ftpd is running out of inetd
ftpd_flags=NO		# for non-inetd use: "-D"

# Set to NO if identd is running out of inetd
identd_flags=NO		# for non-inetd use: "-b -elo"

# On some architectures, you must also disable console getty in /etc/ttys
xdm_flags=NO		# for normal use: ""

# For enabling console mouse support (i386 alpha amd64)
wsmoused_flags=NO	# for ps/2 or usb mice: "", serial: "-p /dev/cua00"

# set the following to "YES" to turn them on
rwhod=NO
nfs_server=NO		# see sysctl.conf for nfs client configuration
lockd=NO
amd=NO
pf=NO			# Packet filter / NAT
ipsec=NO		# IPsec
portmap=NO		# Note: inetd(8) rpc services need portmap too
inetd=YES		# almost always needed
check_quotas=YES	# NO may be desirable in some YP environments
accounting=NO		# process accounting (using /var/account/acct)

krb5_master_kdc=NO	# KerberosV master KDC. Run 'info heimdal' for help.
krb5_slave_kdc=NO	# KerberosV slave KDC.
afs=NO			# mount and run afs

# Multicast routing configuration
# Please look at netstart(8) for a detailed description if you change these
multicast_host=NO	# Route all multicast packets to a single interface
multicast_router=NO	# A multicast routing daemon will be run, e.g. mrouted

# miscellaneous other flags
# only used if the appropriate server is marked YES above
savecore_flags=			# "-z" to compress
ypserv_flags=			# E.g. -1 for YP v1, -d for DNS etc
yppasswdd_flags=NO		# "-d /etc/yp" if passwd files are in /etc/yp
nfsd_flags="-tun 4"		# Crank the 4 for a busy NFS fileserver
amd_dir=/tmp_mnt		# AMD's mount directory
amd_master=/etc/amd/master	# AMD 'master' map
syslogd_flags=			# add more flags, ie. "-u -a /chroot/dev/log"
pf_rules=/etc/pf.conf		# Packet filter rules file
ipsec_rules=/etc/ipsec.conf	# IPsec rules file
pflogd_flags=			# add more flags, ie. "-s 256"
afsd_flags=			# Flags passed to afsd
shlib_dirs=			# extra directories for ldconfig, separated
				# by space

local_rcconf="/etc/rc.conf.local"

[ -f ${local_rcconf} ] && . ${local_rcconf} # Do not edit this line