www/36.html - diff

Return to 36.html CVS log

Up to [local] / www

Diff for /www/36.html between version 1.18 and 1.19

version 1.18, 2004/09/03 14:52:48

version 1.19, 2004/09/03 23:39:15

Line 101

now supports nested anchors.

<li><a href="http://www.openbsd.org/cgi-bin/man.cgi?query=tcpdrop&sektion=8">tcpdrop(8)</a>,

a command to drop TCP connections.

<li>The NMBCLUSTERS option has been eliminated, replaced by a sysctl with higher values on many platforms.

<li>The NMBCLUSTERS option has been eliminated, replaced by a sysctl

with higher default values on many platforms.

<li>Added support for cksum (three flavours), md4, sha256, sha384 and sha512 to

the <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=md5&sektion=1">md5(1)</a>

command.

Line 145

Line 146

driver for ADMtek ADM8211 802.11b wireless adapters.

driver for ASIX Electronics AX88172 USB Ethernet adaptors.

driver for ASIX Electronics AX88172 USB Ethernet adapters.

driver for Ethernet over USB bridges.

<li>New <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=ichpcib&sektion=4&arch=i386">ichpcib(4)</a>

Line 173

Line 174

<ul>

<li>Kernel memory management improvements now allow the full global

routing table to be kept in memory without customizing or tuning.

<li>Support for IPSEC, both manually keyed and using IKE.

<li>Support for IPsec, both manually keyed and using IKE.

<li>Support for NOPEER community (RFC3706).

<li>Partial support for RFC2858 Multiprotocol Capabilities, currently only

IPv4-unicast is announced.

Line 392

Line 393

</pre></ul>

<p>

If your sparc does not have a CD drive, you can alternatively boot from floppy.

If your SPARC system does not have a CD drive, you can alternatively boot from floppy.

To do so you need to write <i>CD3:3.6/sparc/floppy36.fs</i> to a floppy.

For more information see <a href="faq/faq4.html#MkFlop">FAQ4.1</a>. To boot from

the floppy use one of the two commands listed below, depending on the version of

Line 409

Line 410

will most likely fail.

<p>

If your sparc doesn't have a floppy drive nor a CD drive, you can either

If your SPARC system doesn't have a floppy drive nor a CD drive, you can either

setup a bootable tape, or install via network, as told in the

INSTALL.sparc file.

</ul>