===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/36.html,v
retrieving revision 1.18
retrieving revision 1.19
diff -u -r1.18 -r1.19
--- www/36.html	2004/09/03 14:52:48	1.18
+++ www/36.html	2004/09/03 23:39:15	1.19
@@ -101,7 +101,8 @@
 now supports nested anchors.
 <li><a href="http://www.openbsd.org/cgi-bin/man.cgi?query=tcpdrop&amp;sektion=8">tcpdrop(8)</a>,
 a command to drop TCP connections.
-<li>The NMBCLUSTERS option has been eliminated, replaced by a sysctl with higher values on many platforms.
+<li>The NMBCLUSTERS option has been eliminated, replaced by a sysctl
+with higher default values on many platforms.
 <li>Added support for cksum (three flavours), md4, sha256, sha384 and sha512 to
 the <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=md5&amp;sektion=1">md5(1)</a>
 command.
@@ -145,7 +146,7 @@
 <li>New <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=atw&amp;sektion=4">atw(4)</a>
 driver for ADMtek ADM8211 802.11b wireless adapters.
 <li>New <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=axe&amp;sektion=4">axe(4)</a>
-driver for ASIX Electronics AX88172 USB Ethernet adaptors.
+driver for ASIX Electronics AX88172 USB Ethernet adapters.
 <li>New <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=cdce&amp;sektion=4">cdce(4)</a>
 driver for Ethernet over USB bridges.
 <li>New <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=ichpcib&amp;sektion=4&amp;arch=i386">ichpcib(4)</a>
@@ -173,7 +174,7 @@
 <ul>
 <li>Kernel memory management improvements now allow the full global
 routing table to be kept in memory without customizing or tuning.
-<li>Support for IPSEC, both manually keyed and using IKE.
+<li>Support for IPsec, both manually keyed and using IKE.
 <li>Support for NOPEER community (RFC3706).
 <li>Partial support for RFC2858 Multiprotocol Capabilities, currently only
 IPv4-unicast is announced.
@@ -392,7 +393,7 @@
 </pre></ul>
 
 <p>
-If your sparc does not have a CD drive, you can alternatively boot from floppy.
+If your SPARC system does not have a CD drive, you can alternatively boot from floppy.
 To do so you need to write <i>CD3:3.6/sparc/floppy36.fs</i> to a floppy.
 For more information see <a href="faq/faq4.html#MkFlop">FAQ4.1</a>. To boot from
 the floppy use one of the two commands listed below, depending on the version of
@@ -409,7 +410,7 @@
 will most likely fail.
 
 <p>
-If your sparc doesn't have a floppy drive nor a CD drive, you can either
+If your SPARC system doesn't have a floppy drive nor a CD drive, you can either
 setup a bootable tape, or install via network, as told in the
 INSTALL.sparc file.
 </ul>
@@ -594,7 +595,7 @@
 alt="OpenBSD"></a>
 <a href="mailto:www@openbsd.org">www@openbsd.org</a>
 <br><small>
-$OpenBSD: 36.html,v 1.18 2004/09/03 14:52:48 brad Exp $
+$OpenBSD: 36.html,v 1.19 2004/09/03 23:39:15 saad Exp $
 </small>
 
 </body>