version 1.66, 2006/09/19 15:40:43 |
version 1.67, 2006/09/19 16:01:17 |
|
|
<li><a href="http://www.openbsd.org/cgi-bin/man.cgi?query=bioctl&sektion=8">bioctl(8)</a> has been extended to provide runtime information on rebuilds, scrubs and initialization. |
<li><a href="http://www.openbsd.org/cgi-bin/man.cgi?query=bioctl&sektion=8">bioctl(8)</a> has been extended to provide runtime information on rebuilds, scrubs and initialization. |
<li>New sysctls to check the system vendor, product, version, and UUID. |
<li>New sysctls to check the system vendor, product, version, and UUID. |
<li>Equal cost multipath routing support. Needs to be enabled by a sysctl. |
<li>Equal cost multipath routing support. Needs to be enabled by a sysctl. |
|
<li>Prebind, a secure implementation of prelinking, has been added to |
|
<a href="http://www.openbsd.org/cgi-bin/man.cgi?query=ldconfig&sektion=8" >ldconfig(8)</a>, |
|
it speeds up launching of shared binaries. Prebind is compatible with |
|
address space randomization, unlink prelink. |
</ul> |
</ul> |
<p> |
<p> |
|
|
|
|
<h3><font color="#e00000">OpenBSD/armish:</font></h3> |
<h3><font color="#e00000">OpenBSD/armish:</font></h3> |
<ul> |
<ul> |
<p> |
<p> |
Boot over the network by following the instructions in INSTALL.armish. |
After connecting a serial port, Thecus can boot directly from the network |
|
either tftp or http. Configure the network using fconfig, reset, |
|
then load bsd.rd, see INSTALL.armish for specific details. |
|
IOData HDL-G can only boot from an EXT-2 parititon. Boot into linux |
|
and copy 'boot' and bsd.rd into the first partition on wd0 (hda1) |
|
then load and run bsd.rd, preserving the wd0i (hda1) ext2fs partition. |
|
More details are available in INSTALL.armish. |
</ul> |
</ul> |
|
|
<p> |
<p> |