version 1.81, 2006/09/20 16:08:08 |
version 1.82, 2006/09/20 21:56:57 |
|
|
and GPS receivers supported by |
and GPS receivers supported by |
<a href="http://www.openbsd.org/cgi-bin/man.cgi?query=nmea&sektion=4">nmea(4)</a>. |
<a href="http://www.openbsd.org/cgi-bin/man.cgi?query=nmea&sektion=4">nmea(4)</a>. |
<li>Adjust the kernel tick frequency, using |
<li>Adjust the kernel tick frequency, using |
<a href="http://www.openbsd.org/cgi-bin/man.cgi?query=adjfreq&sektion=2">adjfreq(3)</a>, |
<a href="http://www.openbsd.org/cgi-bin/man.cgi?query=adjfreq&sektion=2">adjfreq(2)</a>, |
improving accuracy on many machines. |
improving accuracy on many machines. |
<li>allow for weight to be added to sensors or servers, so that one can |
<li>allow for weight to be added to sensors or servers, so that one can |
weight timedelta sensors higher than ntp peers |
weight timedelta sensors higher than ntp peers |
|
|
After connecting a serial port, Thecus can boot directly from the network |
After connecting a serial port, Thecus can boot directly from the network |
either tftp or http. Configure the network using fconfig, reset, |
either tftp or http. Configure the network using fconfig, reset, |
then load bsd.rd, see INSTALL.armish for specific details. |
then load bsd.rd, see INSTALL.armish for specific details. |
IOData HDL-G can only boot from an EXT-2 parititon. Boot into linux |
IOData HDL-G can only boot from an EXT-2 partition. Boot into linux |
and copy 'boot' and bsd.rd into the first partition on wd0 (hda1) |
and copy 'boot' and bsd.rd into the first partition on wd0 (hda1) |
then load and run bsd.rd, preserving the wd0i (hda1) ext2fs partition. |
then load and run bsd.rd, preserving the wd0i (hda1) ext2fs partition. |
More details are available in INSTALL.armish. |
More details are available in INSTALL.armish. |