This is a partial list of new features and systems included in OpenBSD 4.0.
For a comprehensive list, see the changelog leading
@@ -424,7 +410,6 @@
Following this are the instructions which you would have on a piece of
paper if you had purchased a CDROM set instead of doing an alternate
@@ -439,27 +424,46 @@
extensive details on how to install OpenBSD 4.0 on your machine:
-
-
-How to install
-
-
+
-# dd if=<file> of=/dev/<device> bs=32k +# dd if=<file> of=/dev/<device> bs=32k
@@ -599,8 +603,8 @@
-Write FTP:4.0/alpha/floppy40.fs or -FTP:4.0/alpha/floppyB40.fs (depending on your machine) to a diskette and +Write 4.0/alpha/floppy40.fs or +4.0/alpha/floppyB40.fs (depending on your machine) to a diskette and enter boot dva0. Refer to INSTALL.alpha for more details.
@@ -622,7 +626,7 @@
After updating the firmware to at least ABLE 1.95 if necessary, boot -FTP:4.0/cats/bsd.rd from an ABLE-supported device (such as a CD-ROM +4.0/cats/bsd.rd from an ABLE-supported device (such as a CD-ROM or an existing FFS or EXT2FS partition).
Boot MacOS as normal and extract the Macside "BSD/Mac68k Booter" utility from -FTP:4.0/mac68k/utils onto your hard disk. Configure the "BSD/Mac68k +4.0/mac68k/utils onto your hard disk. Configure the "BSD/Mac68k Booter" with the location of your bsd.rd kernel and boot into the installer. Refer to the instructions in INSTALL.mac68k for more details. @@ -689,12 +693,12 @@ Using the Linux built-in graphical ipkg installer, install the openbsd40_arm.ipk package. Reboot, then run it. Read INSTALL.zaurus for a few important details. -
src.tar.gz contains a source archive starting at /usr/src. This file contains everything you need except for the kernel sources, which are @@ -714,7 +718,7 @@
# mkdir -p /usr/src/sys # cd /usr/src -# tar xvfz /tmp/sys.tar.gz +# tar xvfz /tmp/sys.tar.gz
@@ -724,9 +728,7 @@ Using these files results in a much faster initial CVS update than you could expect from a fresh checkout of the full OpenBSD source tree. -
-# cd [portsdir]/; cvs -d anoncvs@server.openbsd.org:/cvs update -Pd -rOPENBSD_4_0 +# cd [portsdir]/; cvs -d anoncvs@server.openbsd.org:/cvs update -Pd -rOPENBSD_4_0
[Of course, you must replace the local directory and server name here with the location of your ports collection and a nearby anoncvs server.]
-Note that most ports are available as packages through FTP. Updated +Note that most ports are available as packages on our mirrors. Updated packages for the 4.0 release will be made available if problems arise.
If you're interested in seeing a port added, would like to help out, or just -would like to know more, the mailing list ports@openbsd.org is a good -place to know. +would like to know more, the mailing list +ports@openbsd.org is a good place to know.