===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/40.html,v
retrieving revision 1.81
retrieving revision 1.82
diff -u -r1.81 -r1.82
--- www/40.html	2006/09/20 16:08:08	1.81
+++ www/40.html	2006/09/20 21:56:57	1.82
@@ -371,7 +371,7 @@
     and GPS receivers supported by
     <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=nmea&amp;sektion=4">nmea(4)</a>.
 <li>Adjust the kernel tick frequency, using 
-    <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=adjfreq&amp;sektion=2">adjfreq(3)</a>,
+    <a href="http://www.openbsd.org/cgi-bin/man.cgi?query=adjfreq&amp;sektion=2">adjfreq(2)</a>,
     improving accuracy on many machines.
 <li>allow for weight to be added to sensors or servers, so that one can
     weight timedelta sensors higher than ntp peers
@@ -610,7 +610,7 @@
 After connecting a serial port, Thecus can boot directly from the network
 either tftp or http. Configure the network using fconfig, reset,
 then load bsd.rd, see INSTALL.armish for specific details.
-IOData HDL-G can only boot from an EXT-2 parititon. Boot into linux
+IOData HDL-G can only boot from an EXT-2 partition. Boot into linux
 and copy 'boot' and bsd.rd into the first partition on wd0 (hda1)
 then load and run bsd.rd, preserving the wd0i (hda1) ext2fs partition.
 More details are available in INSTALL.armish.
@@ -798,7 +798,7 @@
 alt="OpenBSD"></a>
 <a href="mailto:www@openbsd.org">www@openbsd.org</a>
 <br><small>
-$OpenBSD: 40.html,v 1.81 2006/09/20 16:08:08 deraadt Exp $
+$OpenBSD: 40.html,v 1.82 2006/09/20 21:56:57 steven Exp $
 </small>
 
 </body>