=================================================================== RCS file: /cvsrepo/anoncvs/cvs/www/Attic/i386-laptop.html,v retrieving revision 1.53 retrieving revision 1.54 diff -c -r1.53 -r1.54 *** www/Attic/i386-laptop.html 2001/07/11 23:01:17 1.53 --- www/Attic/i386-laptop.html 2001/07/13 02:05:01 1.54 *************** *** 50,172 ****
! ! APM: "zzz" suspend works, as does the keyboard ! suspend. "halt -p" and "apm -S" ! don't. (but I've yet to look for phdisk utilities below - will be ! investigating shortly.)
! DVD drive, floppy all function. Ethernet works after wakeup with ! the card I'm using (3Com 3c589).
! ! Contact Bob Beck.
! Hibernation uses a block at the end of the disk, approximately ! 3-5MB larger than the memory in your machine. To repair hibernation, ! use "phdisk.exe /create /partition" to setup the ! partition. The phdisk program is available on the boot ! floppy image provided on the first recovery CD.
! Built-in ethernet works fine, but occasionally requires reset ! after suspend using ! "ifconfig fxp0 down; ifconfig fxp0 up".
! After a suspend, the profiling clock is not running. Patches are ! being worked on.
! Sound is supported using the ! neo(4) device driver. Sometimes upon boot, a hang happens ! when trying to determine the AC97 mixer type.
! When the memory stick slot is empty, it can cause errors which overflow ! the dmesg buffer, and thus confuse the OpenBSD install program. ! The BIOS Setup, (accessed using F2), has an option to disable the ! memory stick.
! An XF86Config file suitable for use with XFree86 3.3.X may be ! found here. !
! Contact Theo de Raadt.
! Contact Niels Provos. !
! Ships with a PCMCIA modem card (COM One MCC220 Platinium Card), which works.
! Sound works (8 bit only).
! APM behaviour similar to the VAIO z505r, ! except that hibernation has not been tested.
! USB does not work.
! An XF86Config file can be found ! here.
! Contact Markus Friedl.
2.9 (current as of July 2001) basically works fine except for ! halt -p, which doesn't power off. !
apm -z only puts the system into light sleep ! (this may be fixable with phdisk); apm -s does nothing. !
XFree86 4.0 using the S3 savage driver works fine at 1024x768. ! 1200x1024 should be possible but I haven't tried it. ! My XF86Config for XFree86 4.0 may be found ! here. !
Sound works nicely as yds, ac97 and audio0. !
USB is detected but haven't tested it yet. !
All three cardbus slots are configured when docked (two when undocked). ! Sometimes locks up when removing my cheap NE card. !
The internal WinModem is not supported, nor is there yet ! any support for Firewire or the "Jog Dialer". !
Contact Ian Darwin. !
! XFree86 works (800x600 16bpp).
! ! Sounds works.
! ! Lucent modem does not work.
! ! Contact Kevin Lo.
! ! Internal 10/100 Ethernet (for those models that have it). ! Works beautifully with the fxp(4) driver.
! No sound support as of now. People are supposedly working on ! this.
! ! No internal modem support as of now. (It's a winmodem.) ! There is a binary only driver for Linux. There is also the ! linmodem project that is ! trying to make an opensource winmodem driver.
! An XF86Config file can be found ! here.
! Contact Nathan Binkert. !
! Suspend (to ram or disk) does not work under X (X server does not ! restore screen upon resume), but DPMS do (screen is turned off after ! a while if the machine isn't used). BIOS APM settings (for automatic ! suspend) interfere with X server, and should be disabled.
! Suspend to disk needs a DOS (FAT16) partition containing a file named ! "SAVE2DSK.BIN". This file which is created via Dell tools under ! Windows 98 (it's present out of factory), is sized (ram size + 2 or 3 ! MB). An ad hoc DOS partition is thus required (it must be the first ! partition on disk).
! PCMCIA: works except "live" card ejection or insertion (which lock ! the machine, a hard reset is required).
! ! USB: does not work, if enabled, kernel hangs at boot during USB ! controller detection.
! ! Contact Dan Carlsson.
! Sound works.
! XFree86 v3 works in 1024x768x24bpp. XF4 looks better in 16bpp.
! Both PCMCIA slots work.
! USB is detected, but untested. It does not appear to work after ! a suspend.
! An XF4 config file can be found ! here.
! Contact Paul Wang.
! ! Everything on the machine works.
! ! An XF86Config file suitable for use with XFree86 3.3.X may be ! found here. !
! ! Contact Michael Shalayeff.
! Sound works when the BIOS is told to activate SB emulation mode. ! Everything else on the machine works.
! Contact Tom Knienieder. !
! Serial port doesn't work.
! Some tweaks needed for small memory kernel (4Mb).
! X 'works' (thrashes like crazy).
! Contact David Leonard. !
+ + Everything on the machine works.
+ + Contact Michael Shalayeff. +
+ + Sound works, using OSS.
+ + Contact Dan Carlsson. +
+ + APM: "zzz" suspend works, as does the keyboard + suspend. "halt -p" and "apm -S" + don't. (but I've yet to look for phdisk utilities below - will be + investigating shortly.)
+ + DVD drive, floppy all function. Ethernet works after wakeup with + the card I'm using (3Com 3c589).
+ + Contact Bob Beck. +
+ + Hibernation uses a block at the end of the disk, approximately + 3-5MB larger than the memory in your machine. To repair hibernation, + use "phdisk.exe /create /partition" to setup the + partition. The phdisk program is available on the boot + floppy image provided on the first recovery CD.
+ + Built-in ethernet works fine, but occasionally requires reset + after suspend using + "ifconfig fxp0 down; ifconfig fxp0 up".
+ + After a suspend, the profiling clock is not running. Patches are + being worked on.
+ + Sound is supported using the + neo(4) device driver. Sometimes upon boot, a hang happens + when trying to determine the AC97 mixer type.
+ + When the memory stick slot is empty, it can cause errors which overflow + the dmesg buffer, and thus confuse the OpenBSD install program. + The BIOS Setup, (accessed using F2), has an option to disable the + memory stick.
+ + An XF86Config file suitable for use with XFree86 3.3.X may be + found here. +
+ + Contact Theo de Raadt. +
+ Contact Niels Provos. +
+ + Ships with a PCMCIA modem card (COM One MCC220 Platinium Card), which works.
+ + Sound works (8 bit only).
+ + APM behaviour similar to the VAIO z505r, + except that hibernation has not been tested.
+ + USB does not work.
+ + An XF86Config file can be found + here.
+ + Contact Markus Friedl. +
2.9 (current as of July 2001) basically works fine except for + halt -p, which doesn't power off. + +
apm -z only puts the system into light sleep + (this may be fixable with phdisk); apm -s does nothing. + +
XFree86 4.0 using the S3 savage driver works fine at 1024x768. + 1200x1024 should be possible but I haven't tried it. + My XF86Config for XFree86 4.0 may be found + here. + +
Sound works nicely as yds, ac97 and audio0. + +
USB is detected but haven't tested it yet. + +
All three cardbus slots are configured when docked (two when undocked). + Sometimes locks up when removing my cheap NE card. + +
The internal WinModem is not supported, nor is there yet + any support for Firewire or the "Jog Dialer". + +
Contact Ian Darwin. +
! ! Everything on the machine works.
! ! An XF86Config file suitable for use with XFree86 3.3.X may be ! found here. !
! ! Contact Michael Shalayeff. !
! ! Sound works when the BIOS is told to activate SB emulation mode. ! ! Everything else on the machine works.
! ! Contact Tom Knienieder. !
! ! Serial port doesn't work.
! ! Some tweaks needed for small memory kernel (4Mb).
! ! X 'works' (thrashes like crazy).
! ! Contact David Leonard. !
! ! Sound works, using OSS.
! ! Contact Dan Carlsson. !
! ! Suspend (to ram or disk) does not work under X (X server does not ! restore screen upon resume), but DPMS do (screen is turned off after ! a while if the machine isn't used). BIOS APM settings (for automatic ! suspend) interfere with X server, and should be disabled.
! ! Suspend to disk needs a DOS (FAT16) partition containing a file named ! "SAVE2DSK.BIN". This file which is created via Dell tools under ! Windows 98 (it's present out of factory), is sized (ram size + 2 or 3 ! MB). An ad hoc DOS partition is thus required (it must be the first ! partition on disk).
! ! PCMCIA: works except "live" card ejection or insertion (which lock ! the machine, a hard reset is required).
! ! USB: does not work, if enabled, kernel hangs at boot during USB ! controller detection.
! ! Contact Dan Carlsson. !
! ! Everything on the machine works.
! ! Contact Michael Shalayeff. !
! ! XFree86 works (800x600 16bpp).
! ! Sounds works.
! ! Lucent modem does not work.
! ! Contact Kevin Lo. !
!
! ! Internal 10/100 Ethernet (for those models that have it). ! Works beautifully with the fxp(4) driver.
! ! No sound support as of now. People are supposedly working on ! this.
! ! No internal modem support as of now. (It's a winmodem.) ! There is a binary only driver for Linux. There is also the ! linmodem project that is ! trying to make an opensource winmodem driver.
! ! An XF86Config file can be found ! here.
! ! Contact Nathan Binkert. !
!
! ! Sound works.
! ! XFree86 v3 works in 1024x768x24bpp. XF4 looks better in 16bpp.
! ! Both PCMCIA slots work.
! ! USB is detected, but untested. It does not appear to work after ! a suspend.
! ! An XF4 config file can be found ! here.
! ! Contact Paul Wang. !