===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/Attic/i386-laptop.html,v
retrieving revision 1.88
retrieving revision 1.89
diff -c -r1.88 -r1.89
*** www/Attic/i386-laptop.html	2005/02/22 22:23:33	1.88
--- www/Attic/i386-laptop.html	2005/02/25 01:55:34	1.89
***************
*** 591,596 ****
--- 591,634 ----
      </td>
  </tr>
  <tr>
+ 	<td>
+ 	Sony Vaio z505n:
+ 	</td>
+ 	<td>
+ 	<p>
+ 	OpenBSD 3.6-current (as of August 2004) runs.
+ 	Installation is cumbersome, though. 
+ 	The Sony CD drive does not boot the snapshot CD.
+ 	<p/>
+ 	<p>
+ 	Installation by USB floppy:
+ 	The floppy36.fs of the snapshot (august 2004)
+ 	can be brought to boot if one disables the 
+ 	following (boot -c, wait for the UKC> prompt):
+ 	<pre>
+ 	
+ 	disable pcibios
+ 	disable fxp
+ 	disable pcic
+ 	
+ 	</pre>
+ 	After this there is no USB, no PCMCIA, no Cardbus
+ 	and no network. This means that the laptop has
+ 	no input/output! So you have to put the install sets
+ 	on a partition from some other OS or earlier installations
+ 	of OpenBSD. The install script can mount ffs and msdos
+ 	partitions. The kernel as supplied with the snapshot
+ 	boots alright and recognizes all the relevant hardware
+ 	(no softmodem, no firewire, no memorystick, no JogDial).
+ 	Sound (yds) works. The XFConfig from the OpenBSD install
+ 	works without modification. </p>
+ 	<p>
+ 	Contact <a href="mailto:vaio@weggla.franken.de">Matthias Bauer</a>.
+ 	</p>
+ 	</td>
+ </tr>
+ 	
+ <tr>
      <td>
  	Sony VAIO z505s
      </td><td>
***************
*** 627,632 ****
--- 665,701 ----
      </td>
  </tr>
  <tr>
+     <td>
+ 	Sony VAIO PCG C1XD
+     </td><td>
+ 	OpenBSD 3.6 works, but there are some minor issues:
+ 	<ul>
+ 	<li>USB and built-in sound (Yamaha) work just fine.
+ 	<li>Firewire works with the experimental kernel support
+ 	<li>My 3com Megahertz Cardbus LAN Card works ok.
+ 	<li>Here are my <a href="http://pestilenz.org/~grunk/openbsd/vario/dmesg">dmesg</a> with -current and my <a href="http://pestilenz.org/~grunk/openbsd/vario/XF86Config">XF86Config</a>.
+ 	<li>Jog Dial and the mini camera were useless to me, so I never
+ 	tested them.
+ 	<li>While the GENERIC Kernel works fine, the installation ramdisk
+ 	kernel hangs on booting since OpenBSD 3.3 or so. Disabling the
+ 	cardslot and PCMCIA subsystem in UKC before booting makes the ramdisk
+ 	come up, too. But then you have to install from images you left on
+ 	the hard disk before (e. g. in a discardable filesystem in the
+ 	partition you want to use for swapping later), because you can't
+ 	access LAN or WLAN without the cardslot.
+ 	<li>Removing cards from the PCMCIA/Cardbus slot on a running
+ 	system may cause system freeze or instant reboot sometimes.
+ 	<li>My D-Link DWL-650 (PrismII) works for some time, but then
+ 	locks up and has to be reinserted to work again. This, however,
+ 	causes the problems mentioned above.
+ 	<li>APM works partly: "<b>halt -p</b>" switches off the machine, but
+ 	sometimes, you can't wake up from "<b>zzz</b>".
+ 	</ul>
+ 	Contact <a href="mailto:grunk@pestilenz.org">Alexander von Gernler</a>.
+     </td>
+ <tr>
+ </tr>
+ <tr>
  	<td>Sony VAIO PCG XG700K</td>
  	<td>
  	<p>OpenBSD 2.9 works but had some problems with disklabel/fdisk,
***************
*** 839,845 ****
  <a href="i386.html"><img height=24 width=24 src="back.gif" border=0 alt=OpenBSD></a> 
  <a href="mailto:www@openbsd.org">www@openbsd.org</a>
  <br>
! <small>$OpenBSD: i386-laptop.html,v 1.88 2005/02/22 22:23:33 robert Exp $</small>
  
  </body>
  </html>
--- 908,914 ----
  <a href="i386.html"><img height=24 width=24 src="back.gif" border=0 alt=OpenBSD></a> 
  <a href="mailto:www@openbsd.org">www@openbsd.org</a>
  <br>
! <small>$OpenBSD: i386-laptop.html,v 1.89 2005/02/25 01:55:34 nick Exp $</small>
  
  </body>
  </html>