===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/Attic/i386-laptop.html,v
retrieving revision 1.88
retrieving revision 1.89
diff -u -r1.88 -r1.89
--- www/Attic/i386-laptop.html	2005/02/22 22:23:33	1.88
+++ www/Attic/i386-laptop.html	2005/02/25 01:55:34	1.89
@@ -591,6 +591,44 @@
     </td>
 </tr>
 <tr>
+	<td>
+	Sony Vaio z505n:
+	</td>
+	<td>
+	<p>
+	OpenBSD 3.6-current (as of August 2004) runs.
+	Installation is cumbersome, though. 
+	The Sony CD drive does not boot the snapshot CD.
+	<p/>
+	<p>
+	Installation by USB floppy:
+	The floppy36.fs of the snapshot (august 2004)
+	can be brought to boot if one disables the 
+	following (boot -c, wait for the UKC> prompt):
+	<pre>
+	
+	disable pcibios
+	disable fxp
+	disable pcic
+	
+	</pre>
+	After this there is no USB, no PCMCIA, no Cardbus
+	and no network. This means that the laptop has
+	no input/output! So you have to put the install sets
+	on a partition from some other OS or earlier installations
+	of OpenBSD. The install script can mount ffs and msdos
+	partitions. The kernel as supplied with the snapshot
+	boots alright and recognizes all the relevant hardware
+	(no softmodem, no firewire, no memorystick, no JogDial).
+	Sound (yds) works. The XFConfig from the OpenBSD install
+	works without modification. </p>
+	<p>
+	Contact <a href="mailto:vaio@weggla.franken.de">Matthias Bauer</a>.
+	</p>
+	</td>
+</tr>
+	
+<tr>
     <td>
 	Sony VAIO z505s
     </td><td>
@@ -627,6 +665,37 @@
     </td>
 </tr>
 <tr>
+    <td>
+	Sony VAIO PCG C1XD
+    </td><td>
+	OpenBSD 3.6 works, but there are some minor issues:
+	<ul>
+	<li>USB and built-in sound (Yamaha) work just fine.
+	<li>Firewire works with the experimental kernel support
+	<li>My 3com Megahertz Cardbus LAN Card works ok.
+	<li>Here are my <a href="http://pestilenz.org/~grunk/openbsd/vario/dmesg">dmesg</a> with -current and my <a href="http://pestilenz.org/~grunk/openbsd/vario/XF86Config">XF86Config</a>.
+	<li>Jog Dial and the mini camera were useless to me, so I never
+	tested them.
+	<li>While the GENERIC Kernel works fine, the installation ramdisk
+	kernel hangs on booting since OpenBSD 3.3 or so. Disabling the
+	cardslot and PCMCIA subsystem in UKC before booting makes the ramdisk
+	come up, too. But then you have to install from images you left on
+	the hard disk before (e. g. in a discardable filesystem in the
+	partition you want to use for swapping later), because you can't
+	access LAN or WLAN without the cardslot.
+	<li>Removing cards from the PCMCIA/Cardbus slot on a running
+	system may cause system freeze or instant reboot sometimes.
+	<li>My D-Link DWL-650 (PrismII) works for some time, but then
+	locks up and has to be reinserted to work again. This, however,
+	causes the problems mentioned above.
+	<li>APM works partly: "<b>halt -p</b>" switches off the machine, but
+	sometimes, you can't wake up from "<b>zzz</b>".
+	</ul>
+	Contact <a href="mailto:grunk@pestilenz.org">Alexander von Gernler</a>.
+    </td>
+<tr>
+</tr>
+<tr>
 	<td>Sony VAIO PCG XG700K</td>
 	<td>
 	<p>OpenBSD 2.9 works but had some problems with disklabel/fdisk,
@@ -839,7 +908,7 @@
 <a href="i386.html"><img height=24 width=24 src="back.gif" border=0 alt=OpenBSD></a> 
 <a href="mailto:www@openbsd.org">www@openbsd.org</a>
 <br>
-<small>$OpenBSD: i386-laptop.html,v 1.88 2005/02/22 22:23:33 robert Exp $</small>
+<small>$OpenBSD: i386-laptop.html,v 1.89 2005/02/25 01:55:34 nick Exp $</small>
 
 </body>
 </html>