=================================================================== RCS file: /cvsrepo/anoncvs/cvs/www/anoncvs.html,v retrieving revision 1.59 retrieving revision 1.60 diff -c -r1.59 -r1.60 *** www/anoncvs.html 1998/06/25 08:06:34 1.59 --- www/anoncvs.html 1998/06/25 22:04:23 1.60 *************** *** 277,283 ****

Here is how someone using anoncvs regularly would update his source tree: !

First, startout by `get'-ing an initial tree:

  # setenv CVSROOT anoncvs@anoncvs.ca.openbsd.org:/cvs
--- 277,283 ----
  
  Here is how someone using anoncvs regularly would update his
  source tree:
! 
First, start out by `get'-ing an initial tree:
  
    # setenv CVSROOT anoncvs@anoncvs.ca.openbsd.org:/cvs
***************
*** 418,429 ****
  document
  which describes the setup of anoncvs servers is available.
  
! 
  
  
   
  www@openbsd.org
! 
$OpenBSD: anoncvs.html,v 1.59 1998/06/25 08:06:34 beck Exp $
  
  
  
--- 418,441 ----
  document
  which describes the setup of anoncvs servers is available.
  
! Final notes:
! After upgrading your source tree, you should read the comments
! at the top of /usr/src/Makefile before attemping
! a build.  Also, you should build a new kernel before
! doing a make build if possible.  In some cases it make be
! necessary to rebuild and install the config utility before
! you can build the kernel.  If config GENERIC fails this
! is probably the case.
! 
! It is important to note that upgrading from a release to the current tree
! by rebuilding the sources can be rather difficult due to dependencies
! that are often not obvious.  Therefore, it is suggested that you first
! install the latest snapshot before attemping a tree build from source.
  
  

   
  www@openbsd.org
! 
$OpenBSD: anoncvs.html,v 1.60 1998/06/25 22:04:23 millert Exp $