===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/anoncvs.html,v
retrieving revision 1.59
retrieving revision 1.60
diff -u -r1.59 -r1.60
--- www/anoncvs.html	1998/06/25 08:06:34	1.59
+++ www/anoncvs.html	1998/06/25 22:04:23	1.60
@@ -277,7 +277,7 @@
 <p>
 Here is how someone using anoncvs regularly would update his
 source tree:
-<ul><li>First, startout by `get'-ing an initial tree:
+<ul><li>First, start out by `get'-ing an initial tree:
 
 <pre>
 # setenv CVSROOT anoncvs@anoncvs.ca.openbsd.org:/cvs
@@ -418,12 +418,24 @@
 <a href=anoncvs.shar>document</a>
 which describes the setup of anoncvs servers is available.
 
-</dl>
+<h3><font color=#0000e0>Final notes:</font></h3>
+After upgrading your source tree, you should read the comments
+at the top of <KBD>/usr/src/Makefile</KBD> before attemping
+a build.  Also, you should build a new kernel <strong>before</strong>
+doing a <KBD>make build</KBD> if possible.  In some cases it make be
+necessary to rebuild and install the <KBD>config</KBD> utility before
+you can build the kernel.  If <KBD>config GENERIC</KBD> fails this
+is probably the case.
+<p>
+It is important to note that upgrading from a release to the current tree
+by rebuilding the sources can be rather difficult due to dependencies
+that are often not obvious.  Therefore, it is suggested that you first
+install the latest snapshot before attemping a tree build from source.
 
 <hr>
 <a href=index.html><img height=24 width=24 src=back.gif border=0 alt=OpenBSD></a> 
 <a href=mailto:www@openbsd.org>www@openbsd.org</a>
-<br><small>$OpenBSD: anoncvs.html,v 1.59 1998/06/25 08:06:34 beck Exp $</small>
+<br><small>$OpenBSD: anoncvs.html,v 1.60 1998/06/25 22:04:23 millert Exp $</small>
 
 </body>
 </html>