=================================================================== RCS file: /cvsrepo/anoncvs/cvs/www/arm64.html,v retrieving revision 1.24 retrieving revision 1.25 diff -c -r1.24 -r1.25 *** www/arm64.html 2019/06/01 22:54:16 1.24 --- www/arm64.html 2019/08/30 13:34:00 1.25 *************** *** 35,43 ****
! The current target platforms are Allwinner A64/H5, AMD Opteron A1100, ! Marvell ARMADA 7K/8K, Rockchip RK3328/RK3399, Broadcom BCM2837 ! (Raspberry Pi 3) and Socionext SCA11.
The install media includes firmware required to boot the Pine 64/64+ --- 35,43 ----
! The current target platforms are Allwinner A64/H5, Amlogic G12A/B, ! AMD Opteron A1100, Ampere eMAG, Marvell ARMADA 7K/8K, Rockchip RK3328/RK3399, ! Broadcom BCM2837 (Raspberry Pi 3) and Socionext SCA11.
The install media includes firmware required to boot the Pine 64/64+ *************** *** 61,73 ****
! Opteron A1100 machines on the other hand come with a UEFI firmware ! that includes a device tree and can boot off SATA or USB devices without ! board specific boot files on the system disk.
! All other machines that lack UEFI firmware require additional steps to ! create bootable install media. See the OpenBSD/arm64 snapshot installation instructions for further details. --- 61,73 ----
! Ampere eMAG and AMD Opteron systems come with a UEFI firmware in ROM ! and can boot off SATA or USB devices without board specific boot files ! on the system disk.
! Most other machines load their firmware from the boot media and ! require additional steps to create bootable install media. See the OpenBSD/arm64 snapshot installation instructions for further details. *************** *** 89,94 **** --- 89,103 ----
In general other boards/machines that use one of the SoCs listed above ! will work as well as long as UEFI firmware (e.g. U-Boot) and a device ! tree that describes the hardware is available.
In general other boards/machines that use one of the SoCs listed above ! will work as well as long as UEFI firmware (e.g. U-Boot or EDK II ! firmware). Both device trees and ACPI are supported. An updated ! device tree may have to be supplied to make OpenBSD usable. !
! Support for Amlogic G12A/B and Ampere eMAG was added after OpenBSD 6.5 ! was released.