=================================================================== RCS file: /cvsrepo/anoncvs/cvs/www/arm64.html,v retrieving revision 1.29 retrieving revision 1.30 diff -c -r1.29 -r1.30 *** www/arm64.html 2020/01/17 14:50:25 1.29 --- www/arm64.html 2020/04/15 10:04:09 1.30 *************** *** 37,47 ****
The current target platforms are Allwinner A64/H5, Amlogic G12A/B, AMD Opteron A1100, Ampere eMAG, Marvell ARMADA 7K/8K, Rockchip RK3328/RK3399, ! Broadcom BCM2837 (Raspberry Pi 3) and Socionext SCA11.
The install media includes firmware required to boot the Pine 64/64+ ! and Raspberry Pi.
The Raspberry Pi 3 requires closed but redistributable files on the --- 37,47 ----
The current target platforms are Allwinner A64/H5, Amlogic G12A/B, AMD Opteron A1100, Ampere eMAG, Marvell ARMADA 7K/8K, Rockchip RK3328/RK3399, ! Broadcom BCM2837/BCM2711 (Raspberry Pi 3/4) and Socionext SCA11.
The install media includes firmware required to boot the Pine 64/64+ ! and Raspberry Pi 3.
The Raspberry Pi 3 requires closed but redistributable files on the *************** *** 61,66 **** --- 61,73 ----
+ The Raspberry Pi 4 is only supported when using EDK2-base UEFI + firmware. By default the boot ROM will only try to load the firmware + off an SD card. As with the Raspberry Pi 3 there is no SD/MMC driver + yet, but there are no manual steps needed to boot from a USB disk + drive. + +
Ampere eMAG and AMD Opteron systems come with a UEFI firmware in ROM and can boot off SATA or USB devices without board specific boot files on the system disk. *************** *** 99,107 ****
+ Support for Pinebook Pro and Raspberry Pi 4 was added after OpenBSD + 6.6 was released. +
Snapshots are made available from time to time, in this location