===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/plus.html,v
retrieving revision 1.1031
retrieving revision 1.1032
diff -c -r1.1031 -r1.1032
*** www/plus.html 2006/12/14 16:59:45 1.1031
--- www/plus.html 2006/12/29 06:32:11 1.1032
***************
*** 61,68 ****
!
- Make sk(4) XMAC work on big-endian systems too.
- Add support for Decision Computer multiport serial cards in puc(4).
- Fix sigmask handling bug for landisk platform that caused SIGCHLD to be almost always masked.
- Various fixes for em(4).
--- 61,185 ----
!
! - Activate pwdog(4) on i386 and macppc GENERIC kernels.
!
!
- Added support in the scsi midlayer to handle detached targets better.
!
- Fix malloc() panic in msdos_mountfs().
!
- Remove dpt(4) from alhpa, amd64 and i386 kernels.
!
- Enable new devices (flash, usbf, cdcef) on Zaurus GENERIC.
!
- Initial USB device controller (UDC) and USB CDC Ethernet function support for PXA27x/Zaurus.
!
- Add code to detect if the pwdog(4) card is jumpered to work I/O or memory mapped.
!
- Enable malo(4) on i386 GENERIC kernels.
!
- Add support for the Quancom PWDOG1, watchdog timer card.
!
- Sync the amd64 acpi code to i386, also fix interrupt routing for multi-ioapic systems.
!
- Fix for acpiec handler code, fixes deadlocks.
!
- Initial import of X.org 7.2 called xenocara. Not hooked in the build tree yet.
!
- Initial NAND flash support for Zaurus platform, not enabled yet.
!
!
- Also enable malo(4) devices to have fixed rates set.
!
- Fix for double free panic when detaching interfaces.
!
- Enable automatic rate adaptation on malo(4) devices.
!
- Complete rewrite of the reset routine on bcw(4) devices, clears up the random attach warning on warm boots.
!
- Make sure we zero out the fsid field when copying out a statfs struct to userland in the VFS code.
!
- Add support in pf(4) to tag ipsec traffic belonging to specific IKE-initiated phase 2 traffic. Allows policy-based filtering of encrypted and unencrypted ipsec traffic.
!
- Fix for the STP bridging code, allows to use bridge STP with USB ethernet devices.
!
!
- On arm platforms, use correct define to detect soft cpu.
!
- Remove 802.11a stuff from malo(4).
!
- For now, do not attach the second port on dual port msk(4) cards. Makes the first port work.
!
- Add 88W8310 chipsets to the list of malo(4) devices.
!
!
- Add BCM4312 to the list of bcw(4) devices.
!
- Fix an int overflow in banner(1).
!
- Make sure the kernel malloc() return NULL on too large sizes when caller has set M_CANFAIL instead of panic()ing.
!
- Attach to cardbus bcw(4) cards.
!
- Redo line parsing in ypserv(8), fixes out of bounds array access for short strings.
!
!
- Make wi_get_txpower() fail on USB wi(4), so we do not CSR_READ on them.
!
- In malo(4), free allocated mbufs at TX done. Also reset some TX descriptor values. Fixes "mclpool" warnings.
!
- In ipsecctl(8), do not delete sections that might be shared with other connections. This workaround might leak isakmpd(8) entries, but is ok for now.
!
!
- Added sysctl net.inet6.ip6.multicast_mtudisc for multicast routers.
!
- Fixes for external editor launch in lynx(1).
!
- Remove watchdog handler workaround in em(4), not necessary anymore.
!
- Reenable hardware vlan tagging on ti(4) devices.
!
- Fix a 32 bit overflow on 32 bit platforms for ksh(1) ulimit.
!
- Make bnx(4) only do hardware checksum offload on UDP and TCP.
!
- Fix vlan support in bnx(4) when transmitting frames.
!
- Enable support for audio on landisk platforms.
!
- Add support in pfctl(8) for -K, to kill source tracking nodes explicitly, behaves like -k for killing states.
!
!
- Re-enable Intel i31244 support in pciide(4).
!
- Add support in tcpdump(8) for displaying Rapid Spanning Tree Protocol frames.
!
- Fixes for bnx(4) transmit code which would drop sent packets at mediom/high load.
!
- Add PCI hookup code to malo(4) devices.
!
!
- Fixes for mg(1) regarding isearch.
!
- Fix line number bugs regarding marks while opening same file several times and one concerning pgup/pgdown in mg(1).
!
!
- On amd64, decide whether we need to attach the primary cpu by checking the CPUF_PRESENT, like we do on i386.
!
- Initial import of bcw(4), a driver for IEEE 802.11 Broadcom BCM43xx chipset based devices. Not usable yet.
!
- Add support for multiple networks on one interface for ospfd(8).
!
- In pax(1), fix extracting and setting permissions for tar archives when multiple -C options are present and/or multiple file selection args are used.
!
- Make getpeereid() work on both sides of the connection. The client can now get the euid/egid of the server it connects to.
!
!
- Make sure we copy the IV back into the session structure instead of the softc for VIA cpu-based crypto.
!
- Fix a segfault in mg(1) when using isearch.
!
- Add a lower TX treshold value in em(4) and use this when checking the number of available TX descriptors, in the case that em_encap() has tried to reclaim descriptors.
!
- In grep(1), reset the number of lines of tail context before processing each file, to avoid printing lines from the previous file.
!
- Changed the semantics of ff01::/16 to local interface multicast in the IPv6 stack.
!
- In md5(1), add support for -r and -q options.
!
- Add support for four new radios in zyd(4), AL2210, CGT, Maxim New and Maxim New2. Untested.
!
- All network interface code create empty groups, so the rc scripts can do carp demotion early in the boot process.
!
!
- Various IPv6 utilities transitioned from RFC2292 to RFC3542 behaviour.
!
- Hook up acpi apic interrupt routing support to generic acpi code.
!
- Fix for infinite loop in malo_tx_intr() for malo(4) devices and enable data packet transmission.
!
- Fix integer promotion on 64 bit arches in udcf(4) code.
!
!
- Fix for vge(4) when vge_encap fails, would leave an mbuf in the if_snd queue otherwise.
!
- Add rlog and rannotate commands to OpenCVS.
!
!
- Rework em(3) transmit register handling, required for future chipsets.
!
- Make ipsecctl(8) handle rules with addresses from mismatched address families correctly.
!
!
- Remove a delay() in malo(4) by actually waiting for the command to finish.
!
!
- For i386, get rid of magic ISA and EISA bus numbers in mpbios code, paves way for alternative sources for interrupt information.
!
- Fix memory leak in fsck_msdos(8).
!
- Add support for the 3Com 3CRWE154G72 pgt(4) device.
!
!
- Add support for Sun 1000baseSX cards in gem(4).
!
- Make mopd(8) check the correct bits in the control byte.
!
- Fix DMA firmware command interface in malo(4), now can associate successfully with an AP.
!
- Have em(4) pre-allocate TX DMA maps instead of creating and destroying a DMA map per packet sent.
!
- In the nfe(4) driver, defer setting the valid bit in the first TX descriptor until all descriptors have been set up, otherwise hardware may start processing descriptors faster than us.
!
- In ifconfig(8) for wlan settings, allow -nwid to clear the prefered nwid, just like -nwkey clears the key.
!
- Make m88k-base platforms fetch syscall arguments beyond r9 with copyin() from the userland stack, instead of having the userland code put the first three arguments in r10-r12.
!
- Fix set_rpc_maxgrouplist, so mount_nfs(8) -g works again.
!
- Have md5(1) accept both upper case and lower case letters.
!
- Make ipsecctl(8) check both source and destination when grouping SAs.
!
- Fix grouping for SAs in ipsecctl(8), now all combinations of SAs are possible, not only ESP+AH.
!
- Make sure ipsecctl(8) does not count sa, ike and tcpmd5 rules twice.
!
- Introduce reference count in dvmrpd(8) for route_report so it can be shared and freed correctly.
!
- Make ripd(8) clear lists before deleting neighbor.
!
- Fix an mbuf leak in tun(4) error path.
!
!
- bpf(4) fixes for the acx(4) driver.
!
- Lots of USB devices added to the landisk GENERIC and RAMDISK kernels.
!
- Initial support for OpenBSD/sh support in gdb(1).
!
- Add multicast filter to vic(4) instead of using ALLMULTI all the time.
!
- Make sure diff3(1) respects TMPDIR.
!
- More fixes in malo(4) for the firmware commands.
!
- Make isakmpd(8) support public keys without SubjectPublicKeyInfo.
!
!
- OpenCVS now can do remote tag command.
!
- On landisk platforms, force TS_CARR_ON for the serial console, since they have no DCD line.
!
- Make ospfd(8) and ripd(8) properly indicate the state of "fib-update".
!
- Add a -y flag to fdisk(8) for non-interactive use.
- Make sk(4) XMAC work on big-endian systems too.
+
- Add support for Decision Computer multiport serial cards in puc(4).
- Fix sigmask handling bug for landisk platform that caused SIGCHLD to be almost always masked.
- Various fixes for em(4).
***************
*** 188,194 ****
- Make zyd(4) devices blink the LED on transmit.
- "Bogus xmit rate" panic fixed for rum(4) too.
- Replace rate control code in ral(4), should also fix "bogus xmit rate" panics in HostAP mode.
!
- Make zyd(4) handle per-node rate control
- Add Edimax EW-7318USG to the list of supported rum(4) devices.
- Fixes for rate handling in iwi(4).
--- 305,311 ----
- Make zyd(4) devices blink the LED on transmit.
- "Bogus xmit rate" panic fixed for rum(4) too.
- Replace rate control code in ral(4), should also fix "bogus xmit rate" panics in HostAP mode.
!
- Make zyd(4) handle per-node rate control.
- Add Edimax EW-7318USG to the list of supported rum(4) devices.
- Fixes for rate handling in iwi(4).
***************
*** 206,212 ****
- Another fix for the wscons jump scrolling code which can occur if autowrapping is on and certain control characters are encountered.
- In the VFS layer, promote certain bdwrite calls to bawrite for some cases so they wont get deferred due to pending softdeps.
- Make pciide(4) match the CS5536 IDE controller in AMD Geode LX-800-based system.
!
- Replace ACPI ioctls with APM ioctls, now apmd(8) can be forced to use /dev/acpi.
- Various acpi fixes.
- In sort(1), remove code that could cause a SEGV if a buffer is realloc()ed, instead allocate two buffers early.
--- 323,329 ----
- Another fix for the wscons jump scrolling code which can occur if autowrapping is on and certain control characters are encountered.
- In the VFS layer, promote certain bdwrite calls to bawrite for some cases so they wont get deferred due to pending softdeps.
- Make pciide(4) match the CS5536 IDE controller in AMD Geode LX-800-based system.
!
- Replace ACPI ioctls with APM ioctls, now apmd(8) can be forced to use /dev/acpi.
- Various acpi fixes.
- In sort(1), remove code that could cause a SEGV if a buffer is realloc()ed, instead allocate two buffers early.
***************
*** 331,337 ****
- In grep(1), allow zero-length patterns with -x.
- Make pthreads allocate stack using mmap instead of malloc.
- More of the fd race and deadlock corrections in pthread code.
!
- Make sure bge(4) does not allocate jumbo buffers and also does not allow reception of large frames until mtu is set to higher value.
- On acx(4), make HostAP mode work, and fix IBSS tweaks.
- Add ELECOM LD-USB20 to list of supported aue(4) devices.
- Endian fix for ISO chksum in dvmrpd(8).
--- 448,454 ----
- In grep(1), allow zero-length patterns with -x.
- Make pthreads allocate stack using mmap instead of malloc.
- More of the fd race and deadlock corrections in pthread code.
!
- Make sure bge(4) does not allocate jumbo buffers and also does not allow reception of large frames until mtu is set to higher value.
- On acx(4), make HostAP mode work, and fix IBSS tweaks.
- Add ELECOM LD-USB20 to list of supported aue(4) devices.
- Endian fix for ISO chksum in dvmrpd(8).
***************
*** 416,422 ****
www@openbsd.org
!
$OpenBSD: plus.html,v 1.1031 2006/12/14 16:59:45 pvalchev Exp $