===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/plus.html,v
retrieving revision 1.1277
retrieving revision 1.1278
diff -c -r1.1277 -r1.1278
*** www/plus.html 2013/03/19 12:10:38 1.1277
--- www/plus.html 2013/03/23 00:59:59 1.1278
***************
*** 74,79 ****
--- 74,123 ----
+
+ - Limit the identd(8) client to 256 bytes of input. If they send too much, just close the connection.
+
- Timeout based on the whole identd(8) session, not after every read/write. Stops clients from consuming fds on the server.
+
- Handle EMFILE/ENFILE from accept by disabling handling of events on the identd(8) listeners for a second.
+
- New identd(8) daemon, to replace the libexec one often run from inetd(8). An event driven non-blocking implemention.
+
- Added an interface to rebind agp(4) DMA mappings. For KMS to reload bindings after suspend/resume.
+
- Set glxpcib(4/loongson) "Power Immediate" bit upon attaching, so Fuloong can auto restart upon power failure.
+
- Updated nginx(8) to 1.2.7.
+
- Correct the clock speeds used to calculate int moderation values provided by the SK_IM_USECS() macro on msk(4) and sk(4).
+
- Added workaround for HW bug in bge(4) BCM5717/BCM5718/BCM5719-A0/BCM5720-A0 chipsets: don't include interface input drop counter in input errors.
+
+
- Apply the "AcceptPerfectMatch" workaround for sis(4) DP83815 chipsets to the 15D revision as well.
+
- Fixed size of unicast rx filter table on vio(4), to stop unicast address overwriting part of the multicast rx filter table.
+
- Updated fonts-conf(5).
+
+
- Allow tftpd(8) option ACK to negotiate 2 byte transfers with extra options.
+
- Fixed double free which occurred if a tftpd(8) option ACK failed.
+
- Don't unconditionally try to attach octcf(4) to a CF bus on octeon. Stops endless faults on the EdgeRouter Lite.
+
- Removed the unused sequencer(4) driver.
+
+
- Re-enabled build of Xserver(1) on hp300.
+
- Enable vge(4) flow control support.
+
- Fixed mii(4) flow control support; workaround for the IP1001 PHY where downshift support was not functioning properly.
+
- Install npppd.conf(5) with permissions of 0640, as there could be the radius config in this file.
+
- Disabled pie for lkm(4).
+
- Removed faithd(8) and faith(4).
+
+
- Make sure dhclient(8) doesn't delete IPv6 routes.
+
- Allow octeon to reboot by poking the right address for a soft cpu reset.
+
- In aucat(1) debug mode, log successful connections.
+
- Stopped sndiod(1) and aucat(1) displaying warnings if accept() returns ECONNABORTED or EWOULDBLOCK, as we do in other daemons.
+
+
- Fake "SMBIOS detection" for quirky Soekris boxes, to make it easier to attach device drivers.
+
- Require that the mktemp(1) template include at least 6 trailing Xs to match POSIX mkstemp/mkdtemp. Improved error messages.
+
- Fixed kernel profiling on MP systems by using per-CPU buffers and teaching kgmon(8) to deal with them.
+
+
- Allow snmpd(8) report new PF "translation" counter.
+
- Add pf(4) "translation" counter, use this (not "memory") when address translation fails due to no free ports in the configured range.
+
- Turn identd(8) off by default.
+
- Allow systrace(1), identd(8), uucpd(8), iked(8), nfsd(8), talk(1), tcpbench(1), bgpd(8), dvmrpd(8), ftp-proxy(8), inetd(8), iscsid(8), ldpd(8), ospf6d(8), ospfd(8), ppp(8), relayd(8), ripd(8), sasyncd(8), smtpd(8), snmpd(8) and syslogd(8) to handle ECONNABORTED errors from accept(2).
+
- When binding a lease, check for and clear out any "zombie" routes left behind by a dead dhclient(8).
+
- As per RFC 2131, stop dhcpd(8) ACK'ing any REQUEST containing a server-identifier option that specifies a different dhcp server.
+
- Removed the -I option from ndp(8).
+
- Do not start npppd(8) if a pptp tunnel is configured but the gre(4) protocol is not enabled.
- Flush writes to BGE_MI_COMM to avoid "APE lock request failed!" errors with HP 331T (5719) and 332T (5720) bge(4) cards.
- Changed relayd(8) to use the monotonic clock instead of gettimeofday() and call fatal() on error-that-should-not-happen.
***************
*** 145,152 ****
www@openbsd.org
!
$OpenBSD: plus.html,v 1.1277 2013/03/19 12:10:38 brett Exp $