We are working on OpenBSD-current.
! The following list sums up (almost) all the changes made up to April 9.
-
+
+
- Use vendor ID register for chip-matching in it(4) instead of configuration register patterns. +
- During install, create all disk, CD, and tape devices found in dmesg.boot, instead of just the ones used during install. +
- If, at boot, we find an /etc/resolv.conf.save, swap it back so we're in the right state when we start. + +
- Fix rbus on big memory i386 machines (used by cbb(4) pcmcia). +
- On zaurus, synchronize synchronize ADS7846 and LCD communication to avoid jitter in touchscreen input. +
- Simplify and unify zssp(4) code. +
- In mount_* utilities, properly handle realpath(3) failure. +
- Enable checksum offloading and VLAN frame rx in re(4) and vge(4). +
- In pxaudc(4), clean up properly in case of attachment failure. + +
- Handle at least the first port of a dual-port ufdti(4). +
- Recognize QLogic 2312 and 6312, Dell OEM 2312 isp(4) cards. +
- Mount UDF 'c' partitions with no fuss, just as we do with ISO9660 'c' partitions. +
- Plug a memory leak in isakmpd(8) message handling. + +
- Make pdc(4) 64-bit friendly for hppa64. +
- No longer install ti(4) tigon firmware because of unresolved licensing questions. +
- OpenCVS continues to mature. RCS locks now supported. More branching features supported. +
- In ospfd(8), re-check expired LSA for updates before purging it. +
- Better support for short string-based WEP keys from ifconfig(8). But don't use them. + +
- Allow ftp(1) to properly retrieve URIs with colons in them when specified on the command line. +
- Fix some incorrect register comparisons in creator(4). +
- Begin simplifying code in isakmpd(8). We have some cool features coming that need this. +
- Add support for TCP SACK statistics. +
- Properly protect WANPIPE ioctl(2) in san(4). +
- Enhance detection of supported devices in bioctl(8). +
- Add new -T flag isakmpd(8) to disable NAT-T from the command line. Makes binat setups happier. +
- Make ifconfig(8) complain if someone tries to set a multicast MAC address. +
- When media is loaded into SCSI cd(4) drives, do send commands that might confuse the device. Speeds up device initialization. + +
- Support blink and unblink for ami(4) RAID. This lets you identify which drive in an array needs servicing by blinking the drive's LED. +
- Add ipsecctl(8) to the tree: our new IPSEC flow manipulation tool. This allows us to quickly create and tear down IPSEC flows without using IKE. +
- Support ICH6 audio devices in auich(4). You'll find these integrated on many Intel SouthBridge motherboards. +
- Work around a hardware bug in sis(4) with short cables. Also fix excessive collisions in half-duplex mode. +
- Make interrupt sharing work on bge(4). +
- Recognize PRO/Wireless 2915ABG in iwi(4) driver. + +
- Ignore mygate(5) when using dhcp on any interface. Lets you easily switch between a statically-configured interface and a dhcp interface (nice on zaurus). +
- On i386, allow ptrace(2) to examine and change SSE/SSE2 registers. +
- Implement yacc-based parser for sasyncd(8) config. +
- Simple sparc performance improvements: inline some small pmap functions and provide a real pmap_kremove(9) implementation. + +
- In dc(1), fix raise (^) for negative exponents. +
- Initial support for installing/upgrading via IPv6. +
- Fix hostap mode and a device timeout error with ral(4).
- Add initial support for our next platform: hppa64. Matured in mighty ukrainian oak for 23 months.
- Support setting the MTU on ex(4).
***************
*** 224,230 ****
www@openbsd.org
!
$OpenBSD: plus.html,v 1.953 2005/04/02 17:04:35 cloder Exp $