===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/plus.html,v
retrieving revision 1.953
retrieving revision 1.954
diff -u -r1.953 -r1.954
--- www/plus.html 2005/04/02 17:04:35 1.953
+++ www/plus.html 2005/04/09 18:56:13 1.954
@@ -56,10 +56,58 @@
We are working on OpenBSD-current.
-The following list sums up (almost) all the changes made up to April 1.
+The following list sums up (almost) all the changes made up to April 9.
+
+- Use vendor ID register for chip-matching in it(4) instead of configuration register patterns.
+
- During install, create all disk, CD, and tape devices found in dmesg.boot, instead of just the ones used during install.
+
- If, at boot, we find an /etc/resolv.conf.save, swap it back so we're in the right state when we start.
+
+
- Fix rbus on big memory i386 machines (used by cbb(4) pcmcia).
+
- On zaurus, synchronize synchronize ADS7846 and LCD communication to avoid jitter in touchscreen input.
+
- Simplify and unify zssp(4) code.
+
- In mount_* utilities, properly handle realpath(3) failure.
+
- Enable checksum offloading and VLAN frame rx in re(4) and vge(4).
+
- In pxaudc(4), clean up properly in case of attachment failure.
+
+
- Handle at least the first port of a dual-port ufdti(4).
+
- Recognize QLogic 2312 and 6312, Dell OEM 2312 isp(4) cards.
+
- Mount UDF 'c' partitions with no fuss, just as we do with ISO9660 'c' partitions.
+
- Plug a memory leak in isakmpd(8) message handling.
+
+
- Make pdc(4) 64-bit friendly for hppa64.
+
- No longer install ti(4) tigon firmware because of unresolved licensing questions.
+
- OpenCVS continues to mature. RCS locks now supported. More branching features supported.
+
- In ospfd(8), re-check expired LSA for updates before purging it.
+
- Better support for short string-based WEP keys from ifconfig(8). But don't use them.
+
+
- Allow ftp(1) to properly retrieve URIs with colons in them when specified on the command line.
+
- Fix some incorrect register comparisons in creator(4).
+
- Begin simplifying code in isakmpd(8). We have some cool features coming that need this.
+
- Add support for TCP SACK statistics.
+
- Properly protect WANPIPE ioctl(2) in san(4).
+
- Enhance detection of supported devices in bioctl(8).
+
- Add new -T flag isakmpd(8) to disable NAT-T from the command line. Makes binat setups happier.
+
- Make ifconfig(8) complain if someone tries to set a multicast MAC address.
+
- When media is loaded into SCSI cd(4) drives, do send commands that might confuse the device. Speeds up device initialization.
+
+
- Support blink and unblink for ami(4) RAID. This lets you identify which drive in an array needs servicing by blinking the drive's LED.
+
- Add ipsecctl(8) to the tree: our new IPSEC flow manipulation tool. This allows us to quickly create and tear down IPSEC flows without using IKE.
+
- Support ICH6 audio devices in auich(4). You'll find these integrated on many Intel SouthBridge motherboards.
+
- Work around a hardware bug in sis(4) with short cables. Also fix excessive collisions in half-duplex mode.
+
- Make interrupt sharing work on bge(4).
+
- Recognize PRO/Wireless 2915ABG in iwi(4) driver.
+
+
- Ignore mygate(5) when using dhcp on any interface. Lets you easily switch between a statically-configured interface and a dhcp interface (nice on zaurus).
+
- On i386, allow ptrace(2) to examine and change SSE/SSE2 registers.
+
- Implement yacc-based parser for sasyncd(8) config.
+
- Simple sparc performance improvements: inline some small pmap functions and provide a real pmap_kremove(9) implementation.
+
+
- In dc(1), fix raise (^) for negative exponents.
+
- Initial support for installing/upgrading via IPv6.
+
- Fix hostap mode and a device timeout error with ral(4).
- Add initial support for our next platform: hppa64. Matured in mighty ukrainian oak for 23 months.
- Support setting the MTU on ex(4).
@@ -224,7 +272,7 @@
www@openbsd.org
-
$OpenBSD: plus.html,v 1.953 2005/04/02 17:04:35 cloder Exp $
+
$OpenBSD: plus.html,v 1.954 2005/04/09 18:56:13 cloder Exp $