===================================================================
RCS file: /cvsrepo/anoncvs/cvs/www/plus45.html,v
retrieving revision 1.1
retrieving revision 1.2
diff -u -r1.1 -r1.2
--- www/plus45.html 2009/03/04 18:28:00 1.1
+++ www/plus45.html 2009/03/17 14:51:45 1.2
@@ -67,7 +67,66 @@
+
+- Fix quick reuse of TCP states in pf(4).
+
+
- Better NMI handling for m88k, without the AST and softintr parts.
+
- Fixed panic in the acx(4) driver.
+
- Added two ioctls to the apm(4) interface to give other parts a chance to act when a machine suspends, not just apmd(8).
+
+
- Make pfsync(4) bulk update code run under splsoftnet to prevent races.
+
- Fix multicast support in jme(4) and ale(4).
+
+
- Enabled ale(4) on amd64 and i386 GENERIC and RAMDISK_CD kernels.
+
- Added ale(4), a driver for the Atheros AR8121/8113/8114 Ethernet controllers.
+
- Fix pfsync(4) to make ipsec gateway failover work again.
+
- Fix issue with sis(4) chips that report VLAN tagged packets with an RX error even if everything is fine.
+
+
- Added hardware acceleration in gbe(4) to SGI O2 framebuffers.
+
- Teach smtpctl(8) how to reschedule a message even if the retry delay has not expired.
+
- Prevent pfsync(4) from putting packets on the wire if no syncdev is specified.
+
- Added SAS1078DE to the list of supported mfi(4) devices.
+
+
- Better short frame detection in the tcpdump(8) pfsync decoder.
+
- Moved OpenSSH to version 5.2.
+
- Reduce lower bound of uvm_km_pages for machines with less than 16M of physical memory.
+
- Stop enforcing a minimum size for nkmempages by default.
+
- When doing IPv6 MTU discovery, make sure the requested MTU is not less than the minimal v6 MTU minus the size of a frag header.
+
- Added yukon-2 FE+ to the list of supported msk(4) devices.
+
- Limit the amount of file descriptors to create when passing fd's so it will fit the amount the receiver will allow.
+
+
- Make sure OpenCVS properly convert dates between timezones before comparison.
+
- Reworked m88k MP lock logic, now allows for multiuser and parallel kernel builds on MVME197DP boards.
+
- Various OpenCVS improvements and fixes.
+
- Fix kernel crash in the uvideo(4) bulk device code when closing the video stream.
+
+
- Better atomic operations for m88k, makes 197DP machines almost reach multiuser.
+
- Fix for m88k to let M188 kernels compile again.
+
- Let the sdmmc(4) adapters tell the sdmmc layer how many sectors they can transfer with one command. Speeds up some devices by 2.5 times.
+
+
- Make sure the bpf(4) tap is always called with the same interrupt priority level as the tun(4) to prevent races.
+
- Fix an rthreads race in the reaper.
+
- Reworked the Intra-Area-Prefix LSAs in ospf6d(8) to be RFC5340 compliant.
+
- Make ospf6d(8) send the correct nbr state to RDE.
+
+
- Disabled all IGPGART chipsets from the radeondrm driver, since all the tested ones have issues.
+
- Enabled zyd(4) on socppc GENERIC and RAMDISK kernels.
+
+
- Fix installer so it accepts '\' characters as password.
+
- Make the smptd(8) newaliases read aliases path from smtpd.conf(5).
+
- Fix crash related to incorrect initialization of queues in pfsync.
+
- Fix crash in libc mktemp(3) where there filename was all X characters.
+
- Moved mvme68k ethernet buffers higher in memory to allow for larger bsd.rds to load correctly.
+
- Make sysmerge(8) always run pwd_mkdb(8), newaliases(1) and MAKEDEV(8).
+
- RELIABILITY FIX: bgpd(8) issue when attaching its own AS to an AS-PATH sequence of 255 elements.
+A source code patch is available.
+[Applied to stable]
+ - Fix pfctl(8) -v printing of anchors.
+
- Various m88k 88110 SMP fixes.
+
- Disabled kernel memory pool debugging stuff for the release.
+
- Changed max username and password length for sppp(4) to 255.
+
- Fix for crashes on machines with Core i7 chips when trying to read MSR_TEMPERATURE_TARGET.
- Moved the pfsync(4) protocol to v5, which breaks compatibility with previous pfsync(4) versions. Improves performance and allows several types of updates in a single packet.
- Make rdist(1) silently ignore special files which cannot be moved.
@@ -167,7 +226,7 @@
- The MPLS code can now act as an edge node and allow IPv4 packets to enter a label switched path and not just forward MPLS packets.
- Remove undocumented support for -e in ex(1).
- Implemented proper multicast support in tsec(4) for the socppc platform.
-
- Readded "Category" to the sendbug(1) template.
+
- Re-added "Category" to the sendbug(1) template.
- Fixed libstdc++ issues where ports would include <math.h> and expect C99 macros in that file to be available.
- Enable -d for the export command of OpenCVS.
- Fix sti(4) font selection.
@@ -210,7 +269,7 @@
- Make libkvm operations on live kernels use the sysctl interface.
- Make sysctl(8) change of the value of kern.clockrate set errno on failure.
-
- Fix for Sun USB keyboard when getting layout information for swedish and brittish country codes.
+
- Fix for Sun USB keyboard when getting layout information for Swedish and Brittish country codes.
- Extended ifb(4) code handle XVR-600 and XVR-1200 acceleration.
- Updated time zone data to tzdata2009a.
- Added borderwidth as a cwmrc(5) keyword.
@@ -232,7 +291,7 @@
- Make alpha ES40 machines recognize environmental change machine checks.
- 32-bit fixes for savecore(8).
-
- Fix state leak in pf(4) triggered by certain icmp types matchin a NAT rule.
+
- Fix state leak in pf(4) triggered by certain icmp types matching a NAT rule.
- Make it possible for sparc64 to boot from vdsk(4) devices.
- Make azalia(4) support 20 and 24-bit sample formats.
- Fix audio(4) so it can deal with sample precisions that are not a power of 2.
@@ -358,7 +417,7 @@
- Removed deprecated xf86-video-i810 and xf86-video-nsc.
- Reenabled xf86-video-i740 and xf86-video-voodoo.
-
- Make bge(4) schedule a timeout of it can't put enough packets on the RX ring.
+
- Make bge(4) schedule a timeout if it can't put enough packets on the RX ring.
- Add firmware load for iSight first generation devices to uvideo(4).
- Use the RXO (RX Overflow) interrupt in em(4) to try to refill the RX ring.
@@ -554,7 +613,7 @@
- Better initialization for BCM5906 based bge(4) devices.
- Set default coalescence factor to 64 for both RX and TX on jme(4) devices.
- Make libsndio expose the block size in the sndio API.
-
- Fix for gem(4) TX FIFO treshold underruns.
+
- Fix for gem(4) TX FIFO threshold underruns.
- Set default acceleration for i830 graphic chips to EXA.
@@ -599,7 +658,7 @@
- Feed IPv6 flow label in trunk(4) hash calculation.
- for trunk(4), show the ACTIVE flag in ifconfig(8) for the single interface that is active in failover mode.
-
- Readded TX Vlan tag insertion on nge(4), and RX Vlan tag stripping for nfe(4).
+
- Re-added TX Vlan tag insertion on nge(4), and RX Vlan tag stripping for nfe(4).
- Fix for 4-channel output on auich(4) for SiS 7012-based devices.
- Try harder to use ACPI on i386 machines.
- Updated Time Zone data to tzdata2008i.
@@ -633,7 +692,7 @@
- RX vlan stripping for ti(4) and bnx(4).
-
- Readded RX vlan tag stripping to bge(4), and em(4), and TX vlan insertion for em(4).
+
- Re-added RX vlan tag stripping to bge(4), and em(4), and TX vlan insertion for em(4).
- In mpe(4), prevent users from assigning reserved labels to interfaces.
- Make ftp(1) handle resume when local file does not exist.
@@ -798,8 +857,8 @@
- Fix probing on SGI machines for com@ioc.
- Updated xf86-video-cirrus to 1.2.1.
-
- Added support in gdb(1) for reading auxilliary vectors.
-
- Make it possible to get the ELF auxilliary vector through ptrace(2).
+
- Added support in gdb(1) for reading auxiliary vectors.
+
- Make it possible to get the ELF auxiliary vector through ptrace(2).
- Added netstat(8) statistics for pflow(4).
- Added support in DDB for SMP powerpc machines.
@@ -874,7 +933,7 @@
- Fix vi(1) cscope support in the case that someone provided a filename without a directory.
- Added support for AMD Family 11h (Turion X2 Ultra et al) in km(4).
-
- Fix re(4) multicast/promiscous handling.
+
- Fix re(4) multicast/promiscuous handling.
- Added WPA support to iwi(4).
- Make sure the bwi(4) driver does not try to attach rev 2 BCM431[1-2] chipsets, as they require v4 firmware and bwi(4) currently uses v3.
- Added WPA support for ipw(4).
@@ -936,7 +995,7 @@
- Updated pcc from the master repo. Can now compile both userland and kernel (with some patches).
-
- Let m4(1) be more liberal in include handling and stop skipping spaces outside of paranthesis.
+
- Let m4(1) be more liberal in include handling and stop skipping spaces outside of parentheses.
- Added an option to force TCP lookups in resolv.conf(5) and extend nameserver declaration syntax to support port numbers.
@@ -1031,7 +1090,7 @@
www@openbsd.org
-
$OpenBSD: plus45.html,v 1.1 2009/03/04 18:28:00 deraadt Exp $
+
$OpenBSD: plus45.html,v 1.2 2009/03/17 14:51:45 jj Exp $