If your laptop isn't listed below doesn't mean that it won't work,
and you will most likely find a similar model that is listed below.
Most laptops work very well, however some will still have minor issues.
If you have your laptop working (or not working) and it isn't listed below,
please mail www@openbsd.org so that it
can be listed. Please supply as much information as possible.
Laptop |
Notes |
Acer Aspire 1360
|
- OpenBSD 3.7 works.
- It comes with AMD Sempron 2800+.
- Everything works fine (mini-PCI slot, VIA S3 Unichrome PRO, VIA
RhineII-2).
Contact Maxim
Bourmistrov.
dmesg
¦
xorg.conf
|
Dell Inspiron 4100
|
- OpenBSD 3.7 works.
- apmd(8) is fully functional.
- Integrated xl(4) works fine.
- Integrated auich(4) works fine.
- USB works fine with my mouse.
- Both PCMCIA slots work.
- The Modem does not work.
Contact Robert Nagy.
dmesg
¦
xorg.conf
|
Fujitsu Siemens Amilo D 7820
|
- OpenBSD 3.6 works.
- APM is not working (boot with boot -c and then disable apm).
- Sound works fine.
- Everything else on the machine works.
Contact Alexander Schmid.
dmesg
¦
XF86Config
|
IBM Thinkpad 701C
|
- All features including hibernation and APM work.
Contact Todd Fries.
|
IBM Thinkpad 760
|
- As of OpenBSD 2.6, XFree86 and APM do not work.
- Newer versions of XFree86 support X, and patches are available.
- MWave modem/sound does not work.
- APM has been fixed post-2.6 as well, and patches are forthcoming.
Contact Todd Fries.
|
IBM Thinkpad T23 model 26478NU.
|
- Works fine with OpenBSD 3.7-current (April 2005).
- If using a boot floppy the system may hang when probing ahc.
Workaround: boot with -c and disable ahc.
A GENERIC kernel does not have this issue.
- Serial ports must be enabled in BIOS.
- "ctrl:nocaps" in X puts the control key in a proper location
- Apm mostly works -- suspends OK
- Hibernation not tested, but should work with
/usr/ports/sysutils/tphdisk from the ports collection.
- The audio chipset is supported (auich).
- See http://www.snafu.org/t23/
for more info.
Contact Marco S Hyman.
dmesg
¦
xorg.conf
|
IBM Thinkpad X31
|
Contact Bernd Ahlers.
dmesg
¦
xorg.conf
|
IBM Thinkpad X40
|
- OpenBSD 3.7 works fine.
- SD Card Slot and Modem not yet tried.
- The built-in "Intel PRO/Wireless 2200BG" works only with additional
firmware. See
iwi(4)
for more information.
- APM works fine
- If you want to use Hibernation, you must have a small
msdos partition with a save2dsk.bin. For this, you can use
/usr/ports/sysutils/tphdisk.
- Perhaps one of the best supported notebooks because several
developers also use it.
Contact Marcus Popp.
dmesg
¦
xorg.conf
|
JVC MP-XP 7250DE
|
- OpenBSD 3.6-current (October 2004) works.
- Everything works fine except APM and the built-in
SD card reader.
- Since OpenBSD 3.4 the boot loader does not boot correctly from
USB CDROM on this machine -- workaround: take 3.3 and upgrade or
boot via network or PCMCIA floppy.
- The audio chipset is supported. Wireless 802.11b PRISM 2.5 (USB)
is supported, too.
- X (XF4) works fine. More infos (dmesg and XF86Config)
can be found
here.
Contact Joerg Zinke.
|
Sony Vaio z505n
|
Contact Matthias Bauer.
|
Sony VAIO PCG C1XD
|
- OpenBSD 3.6 works, but there are some minor issues.
- USB and built-in sound (Yamaha) work just fine.
- My 3com Megahertz Cardbus LAN Card (xl) works ok.
- Jog Dial and the mini camera were useless to me, so I never
tested them.
- While the GENERIC Kernel works fine, the installation ramdisk
kernel hangs on booting since OpenBSD 3.3 or so. Disabling the
cardslot and PCMCIA subsystem in UKC before booting makes the ramdisk
come up, too. But then you have to install from images you left on
the hard disk before (e. g. in a discardable filesystem in the
partition you want to use for swapping later), because you can't
access LAN or WLAN without the cardslot.
- Removing cards from the PCMCIA/Cardbus slot on a running
system may cause system freeze or instant reboot sometimes.
- My D-Link DWL-650 (PrismII) works for some time, but then
locks up and has to be reinserted to work again. This, however,
causes the problems mentioned above.
- APM works partly: "halt -p" switches off the machine, but
sometimes, you can't wake up from "zzz".
Contact Alexander von Gernler.
dmesg
¦
XF86Config
|
Sony VAIO PCG-SRX77
|
- OpenBSD 3.3 works but there are some quirks.
- Audio works, using the
auich(4)
driver.
- The built-in ethernet works, using the
fxp(4)
driver.
- The cardbus and built-in wireless do not work
without an awful hack.
- USB and the memory stick port work.
- Firewire is currently untested.
- The jog dial is not currently supported.
- APM does not work; the laptop goes to sleep but does not wake up.
- "halt -p" does halt the machine.
Contact Todd Miller.
XF86Config
|
Toshiba Libretto 50CT
|
Contact Todd Miller.
XFree86 4.X
¦
XFree86 3.3.X
|
Toshiba Libretto 100CT
|
- Most of the information listed in the Libretto 50CT entry
apply to the 100CT as well.
- X11 works in 800x400 mode. There are sample XF86Config files for
both.
Contact Todd Miller.
XFree86 4.X
¦
XFree86 3.3.X
|
Toshiba Satellite 2410S
|
- It's running OpenBSD 3.7-current.
- All stuff are working fine (graphics, sound, PCMCIA, APM,
ethernet), except infrared and the built-in SD card reader.
- There's a bug with certain toshiba laptops and XFree/X.org. Ratio is
too quick, and some chars are repeated. To avoid that, disable
X's
kbd handling, and load a modmap with xmodmap.
Contact Alexandre Anriot.
dmesg
¦
xorg.conf
|
Toshiba Satellite 320CDS
|
- Trusty old model. Keep windows around, in at least a minimal
incarnation, as the BIOS setup is done in software, through a
TSETUP program.
- X works fine in 800x600, 16 bits.
- The sound chip can be handled as a windows sound system clone (wss).
This entails disabling the soundblaster clone recognition.
The BIOS setup must also be set to separate channels for playing
and recording. I haven't tried recording.
- PCMCIA cards work. Cardbus models work as well, provided the BIOS
is set to cardbus mode, and not auto-detection.
Contact Marc Espie.
|